![]() ![]() ![]() The default administrator password is not specified. It is recommended to make a note of the current IP address before changing it. To perform the initial setup of the USB device server, set the IP address for your computer to “” (XXX: 0 to 255), and the subnet mask to “255.255.255.0”. The default IP address for the USB device server is ”192.168.100.100”, and the default subnet mask is ”255.255.255.0”. Be sure to check the upper LED turns off and the lower LED lights up in yellow, and then release the switch.Ĭonfirm the IP address of your computer before starting setup. Press and hold the switch on the interface using a pointed tool such as a pen, and turn on the printer.īoth the upper and lower LEDs of the Ethernet port light up. If you forget the IP address of the USB device server or have changed it from its default, follow the procedure below to initialize the USB device server settings: You cannot set the IP address for the USB device server using the control panel of the printer. The printer status does not appear on your computer because the USB device server does not support bidirectional communication. To use the USB device server in an IPv6 environment, it is necessary to change the network settings in an IPv4 environment first. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |